Talk about several maintenance methods when the winding machine breaks down
Winding machine manufacturer to talk about the maintenance method of winding machine: winding machine fault classification nothing more than: Electrical, mechanical, transmission, pneumatic these few (if any), the electrical part is divided into strong and weak current, and winding machine manufacturers in its general design, use and maintenance of CNC system, with consideration of vulnerability, easy fault can give warning and alarm circuit after work, on the one hand, on the screen or operating panel to make any noise, light, such as alarm message, On the other hand, protective orders are issued. Power off or stop the system to ensure safety and prevent further failure.
Machine reset method: under normal circumstances the coiling machine caused by transient failure the machine error, the available hardware reset or switch power supply system in order to eliminate malfunction, if the system working storage area due to voltage instability, plug-in circuit board or pull rectifier switch power supply under-voltage chaos, it must be initialized to the system to clear, should pay attention to ready before removing the current data backup records, If the fault persists after the reset and initialization, perform hardware replacement.
Commissioning program, a reasonable program and run the success is in good condition or not on the basis of the whole system function, some winding parameter setting error may cause system fault or a function is invalid, sometimes caused by the user program error downtime, this can be used in a pilot program to inspect, necessary to correct errors made by the user program, To ensure its normal operation.
Make good use of the adjustable parts: such as winding tension, screen voltage, starting position of the adjustable parts such as line rack adjustment, in maintenance is a simple but effective method. Through the adjustment of adjustable parts, correct some harmless faults. Such as in an enterprise maintenance of a winding machine used for many years, the system screen screen dark, after adjusting the screen power supply voltage is normal.
Spare parts replacement method: in the maintenance of winding machine, replace suspected faulty parts with intact spare parts, maintenance personnel basic judgment of the cause of the fault, this method can be used to quickly diagnose the fault range, and make the winding machine quickly into normal operation, and then the bad parts back to repair, this is a common troubleshooting method.
